Rafil tal-fil

Surface Preparation

All surfaces should be clean, dry and dust free. Any surface contaminants like grease, oil and efflorescence should be removed in order to promote adhesion.

Preparation And Application

Rafil can be mixed by hand or mechanically using a paddle mixer in a clean bucket with 5 to 6 liters of clean water per 25kg bag. Allow the mixture to stand for 5 minutes, then mix again before application. Always wear eye protection and a dust mask during mixing.

To aid adhesion wet the substrate first and then apply the mortar to a maximun depth of 20mm, if more depth is required build up the mortar in layers. Different textures can be achieved by finishing off with a steel jointing tool, sponge or brush. To enhance stain resistance and water ingress apply two coats of RAPROTEX.

Recommendations

Do not apply RAFIL INTERIOR tal-fil:

• Directly on gypsum surfaces or gypsum boards unless they have been previously treated
• At temperatures below +5°C or above +35°C, strong wind, high humidity or rain
• On painted or blistering surfaces
• Do not dilute RAFIL while curing. Protect hands and face as this product is alkaline